Thorn MBM 40W Mercury Lamp for Coal Mines

In 1938 a major improvement was made in the safety and efficiency of lighting the South Wales coal mines, with the development of this miniature mercury vapour lamp by the British Thomson-Houston Company.

The lighting of mines is especially challenging due to the presence of fire damp, a mixture of flammable gases. This requires strict regulations on the use of electricity to avoid sparks and ignition at switches or poor contacts. A much safer form of lighting was pioneered by distributing power via compressed air, driving a small generator in each light fitting which could be turned on by operating an air valve. At first incandescent lamps were employed, but were not optimal due to their limited output and fragile nature.

The development of this 40W type MBM mercury lamp enabled a major advance in both output and robustness. In a novel arrangement it was electrically ballasted by slightly modifying the windings of the AC generator. Unlike other mercury lamps this model does not contain the usual third auxiliary ignition electrode. The generator produced a 500Hz AC supply and at such high frequency, a capacitive antenna consisting of a few turns of wire around the arc tube proved satisfactory, greatly simplifying lamp construction.

The original model employed an ST-shape bulb, the domed top allowing secure mounting of the inner structure. This later example employs heavy steel wires to support the arc tube, and was able to adopt the simpler ellipsoidal bulb. Such lamps were widely used in British coal mines until the 1990s, when they were made obsolete by more efficient fluorescent lamps in special explosion-proof luminaires.
Manufacturer: Thorn EMI
Lamp Power: 40 Watts
Lamp Current: 0.53 Amps
Lamp Voltage: 80-105 Volts
Cap Type: B22d-3/25x26 Ni plated brass + vitrite
Bulb Type: E-55 E-17 in eighths/inch
Bulb Finish: Clear Soda-lime glass
Electrodes: Hollow coil Double carbonate emitter
Arc Length: 11 mm 0.43 inches
Atmosphere: Inner: Hg | Ar (12 atm) Outer: Nitrogen low pressure
Luminous Flux: 1,340 lm @ 100 hours 1,070 lm @ 2000 hours
Luminous Efficacy: 33.5 lm/W @ 100 hours 26.8 lm/w @ 2000 hours
Colour Temperature & CRI: CCT: 6000K CRI: Ra 16
Chromaticity Co-ordinates: CCx: 0.315 CCx: 0.380
Lifetime: 2000 hours to 50% survival
Warm-up & Re-strike Time: 5 minutes 5 minutes
Burning Position: Vertical cap down
Overall Length: 125 ± 4 mm 5 inches
Light Centre Length: 90 mm 3½ inches
Factory: Leicester England
Date of Manufacture: 1988 November Date Code: 83
Original Value: Unknown
References: 1) Thorn Lamp Specification Sheet 91-9055 Issue 2, January 1989
2) Thorn Arc Tube Construction Sheet LR91-PA-011 Issue 4, December 1988
3) Improved Lighting for Mines, H.K. Bourne, Light & Lighting September 1940 pp.142-147
4) Discharge Lamps for Photography & Projection, H. K. Bourne, publ. Chapman & Hall, London, 1948.
5) Electric Discharge Lamps, H. Cotton, publ. Chapman & Hall, London, 1946.
6) Characteristics of Electric Discharge Lamps for Projection, H.K. Bourne, Journal of British Kinematograph Society, London, January 1941.
7) Research on the Production and Utilisation of Light, H. Warren, Transactions of the Illuminating Engineering Society, January 1939.